User manual SILVA X-TRAIL PLUS

[. . . ] This unique light image gives the user peripheral and long distance vision at the same time. For a runner, cross country skier, mountain biker or night orienteer this translates into less head movement, increased control, better balance and more speed. Switch on your headlamp On the right hand side of the head lamp body is the push button which controls the light modes. Both X-Trail and X-Trail Plus Light modes: Max, Mid, Min, Wide, Blink When the headlamp is OFF: Short press ­ starts the headlamp in Max mode Next short press ­ goes to Mid mode Next short press ­ goes to Min mode Next short press ­ goes to Wide mode Next short press ­ back to Max mode When the headlamp is OFF: Long press (more than two seconds) ­ starts the headlamp in Blink mode When the headlamp is ON: Long press (more than two seconds) ­ turns the headlamp off. [. . . ] the battery status indication LED will be on for 5 seconds after power off. X-Trail Green light ­ Battery in good condition (more than 70% remaining) Orange ­ Medium (30%-70% remaining) Red ­ Battery in poor condition (Less than 30% remaining) X-Trail Plus Green light ­ Good to medium condition (More than 20% remaining) Red light ­ Battery in poor condition (Less than 20% remaining) Please note that the battery status levels above will vary depending on battery type, battery age, temperature etc and the percentage values is therefore approximate. Modular system In order to move the headlamp body from the head bracket to either the helmet bracket or the bike bracket, gently press the release button (located on top of the headlamp on the left hand side) forward while lifting the headlamp body. Insert the headlamp body in the bracket and gently press it down until you hear a click sound. Mounting the helmet bracket The helmet attachment comes with pre mounted adhesive on the back for easy mounting on any helmet. The adhesive is a polyethylene foam tape developed to not damage or cause any type of weakness to plastic. Before mounting the helmet bracket on a helmet, make sure the surface is dry and clean. Mounting the bike bracket The bike handle bar attachment is developed for use on bike handle bars with a dimension between 25 and 32 mm. Use these to ensure the correct fitting for your bike and tighten the bottom screw to secure it on to the handle bar. Care To make sure you get maximum performance from your X-Trail headlamp, clean it regularly with a wet cloth to ensure that the front lens and cooling flanges are free from dirt. The X-Trail and X-Trail plus headlamp is equipped with a temperature control function which prevents the headlamp body from overheating by reducing the power to the LEDs. This means that the lower the ambient temperature, the stronger the light output. Note: Always make sure that the batteries are disconnected when the headlamp is stored in a closed compartment such as a bag, pocket or similar. Protecting the environment Headlamp, batteries and packaging should be recycled and must not be thrown in the regular trash. Warranty Silva warrants that, for a period of two (2) years, your Silva Product will be substantially free of defects in materials and workmanship under normal use. silva's liability under this warranty is limited to repairing or replacing the product. if the Product proves defective during the Warranty Period please contact the original place of purchase. Make sure to have your proof of purchase on hand when returning the product. [. . . ] Se till att ha ett inköpsbevis till hands när du returnerar produkten. Se/environment for more information about the Waste Electrical and Electronic Equipment (WEEE) Directive. Parti incluse Unità lampada frontale Montatura frontale Batteria a cintura Cintura di attacco per manubrio di bicicletta Attacco per casco con adesivo Attacco per manubrio di bicicletta Vano batteria e 4 batterie AA alcaline (X-Trail) Vano batteria con batteria a ioni di litio 2, 2Ah (X-Trail Plus) Caricabatteria (X-Trail Plus) Manuale Intelligent light La lampada frontale X-Trail è equipaggiata con Intelligent Light® che è una tecnologia per la diffusione della luce, capace di combinare un proiettore ad ampio angolo con una luce spot a lungo raggio. questo particolare cono luminoso permette all'utilizzatore di avere allo stesso tempo una visione periferica e a lunga distanza. [. . . ]