User manual RYOBI SENSITIVE DETECTOR

[. . . ] Toggle switch to select detection of wood/metal studs (drywall depth up to 19mm for wood or 25mm for metal), deep wood/metal studs (drywall depth up to 38mm for wood or 51mm for metal), and metal rebar · Auto power off after 2 minutes when left unattended · The user is required not to move the unit during calibration. The user should power off and re-calibrate the unit by powering it on again several inches left or right from the previous location. [. . . ] The user should re-calibrate the unit by powering it on again several inches left or right from the previous location, or use Deep Stud mode for scanning studs behind drywalls. Calibration on wall of too high density such as wet painted drywall, concrete and etc. ⷠElectrical wiring and metal/plastic pipes may be near or touching back surface of wall. When the battery is close to empty, the LOW BATTERY icon " " will begin to flash. Remove the battery to prevent deterioration if the unit is to be stored for an extended period of time. It features a large LCD for easy read, a high impact case for durability, and a soft touch rubber grip. ⷠChoose desired detection mode by cycling the various modes with the "MODE" Wood Stud Deep Stud button on the front face of Deep Metal Metal Stud unit. Reminders: Wood Stud Mode - detect wood studs in drywall up to 19mm deep and detects metal studs in drywall up to 25mm deep. Deep Stud Mode - detect wood studs in drywall up to 38mm deep and detects metal studs in drywall up to 51mm deep. Therefore it is warranted against defective parts and labor only and not misuse or deterioration of the product through normal wear and tear for a period of 2 years from date of purchase. [. . . ] WARNING: To avoid risk of electric shock, ALWAYS turn power off when working near electric wires. Avoid nailing, cutting or drilling in walls where electrical or plumbing may be present. [. . . ]