User manual RYOBI RMS-1825

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Placez la scie sur une surface de niveau et plane, offrant un espace suffisant pour permettre la manipulation et un appui correct de la pièce usinée. Faites glisser l'extrémité rainurée du support de fixation du protège-lame inférieur sous la tête de vis et faites pivoter le support de fixation du protège-lame inférieur jusqu'à ce que le trou du support s'aligne avec le trou fileté du protège-lame supérieur. This user's manual describes safety and international symbols and pictographs that may appear on this product. [. . . ] Handle latch The mitre saw can be locked in the lowered position for compact storage. Bevel Lock Handle The bevel lock handle locks the mitre saw at the desired bevel angle. Mitre Lock Handle The mitre lock handle securely locks the mitre saw at the desired mitre angle. Lower Blade Guard The blade guard helps protect your hands when the blade is in the raised position. Mitre Saw Handle The saw handle has a trigger switch with a lock button. The saw will return to its upright position when the handle is released. Unpack all parts and check each item using the illustration and "Table of Unmounted Parts". Make sure all items are accounted for before discarding any packing material. WARNING If any parts are missing, do not try to assemble the mitre saw, plug in the power cable or switch on the machine until the missing parts have been obtained and installed correctly. ITEM A B C D E F G H I J TABLE OF UNMOUNTED PARTS Saw Lower blade guard Instruction manual Dust bag Clamp assembly Side extension arm U-bracket Stop block thumb screw Stop fence plate Thumb screw QTY. WARNING To avoid accidents, please read the following instructions carefully: 1. To avoid back injury, get help when you need to lift the saw more than 30 cm. Carrying the saw by the power cable could cause damage to the insulation or the wire connections resulting in electric shock or fire. Place the saw on a firm, level surface where there is plenty of room for handling and properly supporting the workpiece. If the saw is to be used in one location, fasten it to the work bench. WARNING To avoid accidents caused by unintentional starting or electrical shock, do not plug the saw in until all assembly and alignment steps are complete. The power cable must remain unplugged whenever you are working on the saw. The mitre saw is equipped with a handle latch, used to lock the mitre saw in the lowered position. To change the position of the saw, push the handle down slightly and pull the handle latch upwards. Slide slotted end of lower guard mounting bracket under screw head and rotate lower guard mounting bracket until hole in bracket lines up with threaded hole in upper guard. Replace screw 2, that was removed in step 3 Tighten screw 1 and screw 2. Use the mitre saw handle to swivel the table and saw so that the blade is in contact with the full length of the square. [. . . ] The support should let the workpiece lay flat on the base and work table during the cutting operation. Certain types of moulding need a fence face extension due to the size and position of the workpiece. Holes are provided in the fence to attach an auxiliary fence made of natural wood, 13 mm thick by 8 cm high by 50 cm long. The auxiliary fence is used with the saw in the 0° bevel position. [. . . ]