User manual RYOBI RLT3725-A

[. . . ] A product that cannot be controlled with the switch is dangerous and must be repaired. Avoid accidental starting; never carry the product with your finger on the trigger. Make sure all guards, deflectors and handles are properly and securely attached. Use only the manufacturer's replacement line in the trimmer head. [. . . ] Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. (Without Safety Alert Symbol) Indicates a situation that may result in property damage. Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHORIZED SERVICE CENTRE for repair. wARNING Observe all normal safety precautions related to avoiding electrical shock. WARNING To avoid serious personal injury, do not attempt to use this product until you read thoroughly and understand completely the operator's manual. Save this operator's manual and review frequently for continuing safe operation and instructing others who may use this product. WARNING The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. Main handle Lock-off button Trigger Palm handle Electric power cord Live power indicator Crutch handle (RLT3725CH-A only) Height adjustment button Lower shaft Upper shaft Steel wire guide Rotating release Motor housing Foot pedal (RLT3725CH-A only) Safety guard Spool Bump button Nylon line Bump head Cut-off blade The line trimmer is supplied with some components not assembled. By clutching the upper part of the line trimmer under your right arm and with your left hand holding the lower shaft (9), carefully position the upper shaft (10) over the lower shaft. With your right thumb, push forward the height adjustment button (8) then gradually lower the upper shaft over the lower shaft. Turn/rotate the upper shaft as necessary to ensure it goes onto the lower shaft in the correct orientation. As you insert the upper part over the lower part, take care not to damage the cable and that the cable resides comfortably without strain inside the shafts. Note: There is a paper tag on the shaft to help explain this assembly. It is not possible to disconnect the tubes once they have been assembled/ fixed. Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position. Place the bolt through the front handle as shown, then install the wing nut. Place the bolt through the hole and secure using the nut on the other side. Make sure the height of line trimmer is in most comfortable position before use. Adjust the height by pushing forward the height adjustment button (8), then pulling/pushing the tubes until they click onto the most suitable slot (Fig. [. . . ] Unless specifically provided under applicable law, this warranty does not cover transportation cost or consumable items such as fuses. This limited warranty is void if the product's original identification (trade mark, serial number, etc. ) markings have been defaced, altered or removed or if product is not purchased from an authorized reseller or if product is sold AS IS and / or WITH ALL FAULTS. Subject to all applicable local regulations, the provisions of this limited warranty are in lieu of any other written warranty, whether express or implied, written or oral, including any warranty of MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. [. . . ]