User manual RYOBI RK26-2 VUE GLOBALE

[. . . ] Keep these operating instructions in a safe place and pass them on to any future user. ~ Before installation or service, disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. ~ Do not use an extension cord to connect this appliance to electricity. Extension cords do not guarantee the required safety of the appliance (e. g. , danger of overheating). ~ Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. Warning: At an altitude of more than 8200 ft (2500 m) the glass door can break. [. . . ] Check the display. A large amount of bottles has been put This makes the compressor run for in the appliance at the same time. longer, causing the temperature in the appliance to fall automatically. Once the appliance returns to the set temperature the compressor will turn off. Check that the door has been closed properly. 28 Frequently asked questions What if the alarm is ringing?Possible fault The appliance door has been open for longer than 5 minutes. Solution Close the door. What if the alarm is ringing and the "alarm" indicator is lit?One of these conditions has caused the temperature in the appliance to become too warm. Once the alarm condition has been corrected, the alarm will turn off and the "alarm" indicator will stop flashing. What if the display lighting is not working?The display lighting turns off automatically depending on the time set. If the display lighting still does not turn on after 15 minutes with the door closed, contact Miele Technical Service. A white coating has formed around the wine corks. The corks are made of a material which The white coating can be removed with has caused a chemical reaction a dry cloth. The installation location should not be exposed to direct sunlight, nor near a heat source, such as an oven, radiator, etc. The ambient temperature should not drop below 55 °F (13 °C) or rise above 110 °F (43 °C), otherwise malfunctions may occur. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances from the heat source: ­ 1 1/4" (3 cm) from an electric cooktop or oven. ­ 12" (30 cm) from a gas cooktop or oven. Have the appliance installed by a qualified technician, according to the enclosed installation instructions. , WARNING This appliance is top-heavy and must be secured to prevent the possibility of tipping forward. Keep the door closed until the appliance is completely installed and secured as per the installation instructions. 337 lbs (153 kg) 35 Installation Base A fully loaded appliance is very heavy. The load-bearing capacity of your floor must meet the following requirements: KWT 16x1 Vi . 704 lbs (319 kg) To ensure that the appliance is installed securely and functions properly, the base must be flat, level and made of a hard, rigid material. If in doubt, contact Miele. Installation niche To ensure safe, trouble-free installation and the best possible cosmetic result, check to be sure that the installation space complies with the installation dimensions. The minimum thickness of the side walls and the top wall must be 5/8" (16 mm). The minimum thickness of the toe-kick panel must be ½" (13 mm). [. . . ] If you are in any doubt as to whether the appliance has been properly grounded, have the appliance checked by a qualified electrician or service technician. Installation, repairs and other work by unqualified persons could be dangerous. Before installing the appliance, verify that the voltage, load and circuit rating information found on the data plate match the household electrical supply. If there are any questions regarding the electrical connection of this appliance to the power supply, please consult a licensed electrician or call the Miele Technical Service. [. . . ]