User manual RYOBI RESV1000 SCHEMA ELECTRIC

[. . . ] this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. A small gap will be visible between cooktop and countertop for the first days after installation. The electrical safety of your appliance is warrantied despite the small gap. ~ Do not connect the appliance to the ~ Before servicing, disconnect the ~ To guarantee the electrical safety of ~ Only for frame/facet cooktops: 4 IMPORTANT SAFETY INSTRUCTIONS Use cooking, and for the purposes described in this manual. [. . . ] If the burner is still hot the residual heat indicator will show. Residual heat indicator The bars of the residual heat indicator go out one after another as the burners cool. The last horizontal line only goes out when the burner is safe to touch. Turning off the cooktop ^ Touch the s On/Off control for the cooktop. If any burners are still hot the residual heat indicator will show in the respective display. The residual heat indicator also reacts to hot dishes and plates being placed on a burner that is not switched on. Do not touch any burner or place any heat sensitive items on a burner where the residual heat indicator is lit. Danger of burns, and fire hazard. , Please note that the residual heat indicators do not light when there is a fault message, even if the burners are hot. 23 Timer The cooktop is fitted with a timer which can be used to time kitchen activities and/or to switch off the burners automatically. If the time is more than 99 minutes (99), the setting will be shown in half-hour increments, which appear after the decimal point. To override a stop, briefly remove your finger from the touch control, then touch it again to continue. When the set time has elapsed, 00 will appear in the timer display for a few seconds. To turn the signal off before this, touch the m sensor. Setting the timer The timer can be used with the cooktop turned on or off. ^ While the indicator is flashing, touch the - or + sensor until the desired time appears in the display, e. g. To use this feature the setting has be changed (see "Programming - P7"). Deactivation ^ Press and hold the $ Child Safety Lock control until the indicator goes out. The indicator will come on to show that the Child Safety Lock has been activated, if you touch the $ Child Safety Lock control or try to select a setting. In the case of a power failure the Child Safety Lock will be deactivated. 27 Safety features Stop and Go Your appliance has a Stop and Go feature which, when activated, reduces the power of all burners that have been switched on. If you then deactivate the feature, the burners will automatically return to the previous level. If the feature is not deactivated, the cooktop will turn off after 1 hour. If you wish to use this feature, you will need to alter the factory setting (see "Programming - P1"). To activate Stop and Go: ^ Press and hold the sensor $ until you hear two consecutive beeps. Be careful not to continue touching the $ sensor for too long, as this will activate the safety lock. The power for the activated burner(s) will reduce to level 1, and 1 will appear in the respective display. When activating "Stop and Go": ­ the countdown of the programmed time for the automatic switch-off function will be interrupted. When deactivating "Stop and Go", the countdown will continue, ­ the timer will continue without interruption. To deactivate Stop and Go: ^ Press and hold the $ control until the indicator goes out. The burners will now run at the level previously set. 28 Safety features Safety cut-out feature The cooktop is on too long The cooktop has a safety cut-out feature in case it is not turned off after use. [. . . ] There must be a minimum distance of 4 ½" (110 mm) between the top of the countertop and the top of the protective base to ensure proper ventilation. ~ This appliance has not been designed for maritime use or for use in mobile installations such as recreational vehicles or aircraft. However, under certain conditions it may be possible for installation in these applications. Please contact the Miele Technical Service Department with specific requirements. permanently sealed into the countertop when installed. [. . . ]