User manual RYOBI RBV3000VP SCHEMA

[. . . ] Care should be taken to arrange the cord so that it cannot be pulled or tripped over. Your Rowenta appliance is intended for household use only. SAVE THESE INSTRUCTIONS BEFORE USE Please read the instructions for use and the Important Safeguards carefully. It is normal for a small amount of smoke to be produced the first time the iron is used. 3-WAY AUTO-OFF If the iron is not moved while it is plugged in, an internal safety switch will turn it off. [. . . ] SETTING THE VARIABLE STEAM CONTROL 4 min Self max Clean Set the variable steam control to required steam volume. Steam can only be produced when the thermostat is aligned to qqq (red zone on dial). (If on setting q or qq the variable steam lever should be shut off. ) Allow iron to heat up (light goes out) before activating the steam control. Iron ready for steam ironing Steam is produced as soon as the iron is held horizontally and variable steam lever is moved from the min position. Steam off Steam generation can be interrupted by standing the iron on its heel or sliding the variable steam control fully to the left (min. ) ANTI-DRIP SYSTEM (Depending on model) In order to produce steam, all irons require a high temperature. If the soleplate is not hot enough some of the water will not turn to steam and can spit or leak from soleplate. The antidrip system automatically reduces the volume of steam when ironing at low temperatures to prevent dripping. Moistening the fabric with the spray will make wrinkle removal easier. This is very useful when the three dot setting is too hot for the material being ironed. Do not spray silk, etc. BURST OF STEAM 6 To remove stubborn wrinkles or press in a sharp crease, use the burst of steam button. Press the button firmly, a strong burst of steam penetrates deep into the fabric. Leave an interval of at least four seconds between pressing the burst of steam button. To ensure that your iron continues to steam efficiently the valve MUST be opened and closed a few times after each use. This is done by moving the variable steam control left to right a few times. Steam Chamber Cleaning Function This function allows loose mineral deposits and other impurities that build up inside the iron to be flushed out. This type of self cleaning only needs to be carried out occasionally and never more than once a month. Fill the iron with cold tap water halfway to the max line and set variable steam lever to min. When the iron reaches the correct temperature, indicator light will go out, unplug iron. Hold iron horizontally over the sink with soleplate pointing away from the body. Move variable steam lever completely to the right and hold in self clean position for one minute. WARNING: Doing this will cause steam and hot water to be ejected from the soleplate. Move the iron gently back and forth and side to side until all water has run through. Carefully wipe all water and material from the soleplate with an old towel, as the water and minerals can stain the soleplate (although this has no effect on glide or performance). [. . . ] Most softened water is alright, but if you experience leaks or spitting, change to untreated tap water or inexpensive bottled spring water. The light goes on and off showing the thermostat is switching the heat on and off to maintain the correct temperature. SOFTENED WATER Auto-off activated?enough. If the iron is not hot enough the anti-drip system will activate and stop the iron's steam production. Is variable steam If iron is fitted with a variable steam control correctly set? [. . . ]