User manual RYOBI RBS-3080

[. . . ] Never use the machine when the doors of the sawblade protection mechanism are open. Make sure that the sawblade and speed chosen correspond to the material to be sawn. Risk associated with the inadvertent start of the machine · Disconnect the power plug before opening the machine. Risk associated with environmental factors · Do not place the machine in the rain or in a damp environment. [. . . ] The table must be adjusted on two levels: · Sideways, so that the sawblade turns in the middle of the chip guard; at right angles to the sawblade. With a set square, adjust the table so that it is at right angles to the blade and tightly screw down the retaining screws (32). Loosen the nut (33) and adjust the setting of the dead-stop screw (34) until it touches the saw casing. You can mount the parallel guide either on the right or on the left of the sawblade. The sawdust of certain woods (like oak and ash) can cause cancer when inhaled. Do not work in confined spaces unless you have a sawdust extraction system (air speed in the extraction outlet > 20 m/s). You use your saw for a short period of time (30 minutes of use at the most). When you use your saw without a sawdust extraction system, sawdust builds up: it therefore has to be emptied out on a regular basis. To check the tension, exert slight lateral pressure on the sawblade, mid-way between the table and the upper sawblade guide (the sawblade must have a maximum sideways give of 1 to 2 mm). If it is necessary to correct the tension: Turn the adjustment knob (36) clockwise to increase the tension. Before you plug in your saw, make sure that the following requirements have been met: · Fuse protection with FI switch and leakage current of 30 mA Mains sockets installed according to professional standards, earthed and approved Place the power cable so that it is out of your way and will not be damaged while you work. To reduce the risks of injury, follow the safety instructions below while you work: · Never saw more than one workpiece at a time. When your work, if necessary, use: - A support for large workpieces that may fall off the table once cut. When you make circular cuts, use an appropriate clamping device to avoid twisting of the workpiece. 17) If you saw boards on edge, use an appropriate set square to prevent your board from tilting. Before you start working, make sure that the following parts are in perfect condition: - Sawblade - Upper and lower slides · Adopt a correct working position when you are sawing (the teeth of the saw must face the user). Never saw several workpieces at the same time ­ never saw joined workpieces made up of several parts. There is a risk of accident if workpieces are pulled by the sawblade while unattended. Risk associated with inadequate dress · We advise you not wear loose clothes, jewellery or gloves as they may get caught in the revolving parts of the machine. Never cut any workpiece which has cables, cords, ribbons, rope or wires attached to it. [. . . ] The factors which currently affect nuisance levels on the work site are: the work space itself as well as the other sources of sound nuisance, such as the number of machines and the number of jobs in progress in the neighbourhood. The authorised sound levels on the work site may also vary from one country to another. These few elements of information should however enable the user to better assess the dangers and risks. Risk i samband med intrång av främmande kroppar i maskinen Försäkra er om att inget föremål (ett verktyg till exempel) befinner sig i maskinen när den startas igång. [. . . ]