User manual RYOBI ETS-1526AL

[. . . ] Disconnect the plug when not in use, or when changing accessories, making adjustments, cleaning or working on tool. All tools should be kept out of the reach of children when not in use. Only use accessories that are recommended by the manufacturer of your model. Accessories that may be suitable for one tool may create a risk of injury when used on another tool. [. . . ] Use the extension table for supporting long workpieces during cutting operation. A: Mitre gauge assembly B: Rip fence assembly C: Blade guard assembly D: Leg stand (4pcs) E: Cross Brace (4pcs) F: Push stick G: Blister pack with screws H: Rear Extension Table Input voltage Watts Blade diameter Bore size No load speed Depth of cut at 90O Depth of cut at 45O Main table size Rear Extension table size Sound pressure level Net weight 230 V ~ 50 Hz 1500W 254mm 30mm 4500min-1 80mm 55mm 720mm (W) x 520mm (L) 440mm (W) x 125mm (L) 99dB(A) 23. When the noise level exceeds 85 dB (A) be sure to wear ear protection. This machine is designed to rip and cross cut wood exclusively up to maximum thickness of 80mm. For correct operation it must be fixed and operated as explained in this manual. DO NOT cut timber greater than 80mm DO NOT cut metal, stone, rubber, plastic bones, etc. DO NOT modify the machine or its guards/controls DO NOT run the machine before removing all packaging. Mount the evaluating handle(13) on the shaft on the left hand size of the saw and fix it by tightening the set screw in the handle (fig 1). Turn the elevating handle (13) (Fig 1) in the counterclockwise direction to raise the blade shaft to its highest position (Fig 3). Remove the blade fixing nut by turning in a counterclockwise direction, then pull the outer flange form the shaft and the outer arbor. Mount the blade (15) (be sure that the teeth are facing downwards at the front side of the saw. Check again that the blade is (15) securely tightened and re-fit or adjust riving knife as necessary, before remounting the table insert (17). Insert the riving knife(20), so that the long slots in the riving knife fit around the hexagon socket head end screws(Fig 4). Adjust the riving knjfe(20) so that the clearance between riving knife(20) and blade (15) is between 2 to 5 mm (Fig. Check to ensure the riving knife (20) and saw blade (15) is in line, Then check again that the blade is securely tightened and remount the table insert. Loosen the rip fence lock knobs(5) on the sliding block(19), then slide the fence(6) onto the bolt heads and tighten the rip fence lock knobs(5) (Fig. 6) To lock the rip fence(6), slide the rip fence assembly until the indicator is pointing to the desired setting. Take care that the selection of the saw blade depends on the material to be cut. The Blade(15) has been adjusted at the factory, use a square to check that the blade is o at a 90 angle to the table (Fig. 8) If adjustment is needed turn the tilting lock nut (while holding the adjustment in position) to fix the adjustment. [. . . ] Hold the piece against the fence (6) and feed it through the blade (15) with a smooth, steady pressure. Always use the push stick (16) to feed the workpiece until it is clear of the table. When bevel ripping material of 6" (150mm) or narrower, use only the push stick(16) to feed the workplace past the saw blade. Fasten your dust collector to the back side of the table to the dust port(22) (Fig. [. . . ]