User manual RYOBI ETS-1526

[. . . ] Disconnect the plug when not in use, or when changing accessories, making adjustments, cleaning or working on tool. All tools should be kept out of the reach of children when not in use. Only use accessories that are recommended by the manufacturer of your model. Accessories that may be suitable for one tool may create a risk of injury when used on another tool. [. . . ] DO NOT modify the machine or its guards/controls DO NOT run the machine before removing all packaging. Mount the evaluating handle(13) on the shaft on the left hand size of the saw and fix it by tightening the set screw in the handle (fig 1). Remove the table insert (17) by removing the eight Philips flat head screws. Turn the elevating handle (13) (Fig 1) in the counterclockwise direction to raise the blade shaft to its highest position (Fig 3). Remove the blade fixing nut by turning in a counterclockwise direction, then pull the outer flange form the shaft and the outer arbor. Mount the blade (15) (be sure that the teeth are facing downwards at the front side of the saw. Check again that the blade is (15) securely tightened and re-fit or adjust riving knife as necessary, before remounting the table insert (17). If in place, remove the table insert (17) by removing the eight Philips flat head screws. Insert the riving knife(20), so that the long slots in the riving knife fit around the hexagon socket head end screws(Fig 4). Adjust the riving knjfe(20) so that the clearance between riving knife(20) and blade (15) is between 2 to 5 mm (Fig. Check to ensure the riving knife (20) and saw blade (15) is in line, Then check again that the blade is securely tightened and remount the table insert. Assembly will be easier if all bolts are fitted before any bolts are fully tightened. Fit bolts finger tight during assembly, fully tighten all when assembly is complete. Align the three holes of both left/right extension tables (4&5) with the three holes in the two wings of mind table (Fig. Bolts and spring washers to lock the two end holes & one M6x 16 bolt to fix the middle hole. Align the two holes of rear extension table (18) and with two M6x 12 screw, flat washer, spring washer and M6 nut secure the rear extension table(18) to the main table (Fig. To mount support bars (23) to Extension tables (4, 5 &18) and body (1), use M6 screw, flat washer, spring washer and M6 nuts. Ensure the extension tables are in line and surfaces are flush with the main table. Fully tighten blots when all assembly is complete, if fitting the machine to the leg stand assemble and fit this before tightening the blots. Loosen the rip fence lock knobs(24) on the sliding block(19), then slide the fence(6) onto the bolt heads and tighten the rip fence lock knobs(24) (Fig. 8) To lock the rip fence(6), slide the rip fence assembly until the indicator is pointing to the desired setting. Take care that the selection of the saw blade depends on the material to be cut. [. . . ] Se till alltid att ditt att bordlägga såga med står monteras säkert till det slipat. Om stå inte är att vara choiced för att montera till ditt bordlägger sågar, där är 4 spela golfboll i hål också på bordlägga sågar för montering till workbenchen. Se till alltid att ditt att bordlägga såga monteras säkert till en workbench eller en godkänd workstand. Use the extension table for supporting long workpieces during cutting operation. [. . . ]