User manual RYOBI ETS-1525SC

[. . . ] Disconnect the plug when not in use, or when changing accessories, making adjustments, cleaning or working on tool. All tools should be kept out of the reach of children when not in use. Only use accessories that are recommended by the manufacturer of your model. Accessories that may be suitable for one tool may create a risk of injury when used on another tool. [. . . ] DO NOT cut timber greater than 80mm DO NOT cut metal, stone, rubber, plastic bones, etc. DO NOT modify the machine or its guards/controls DO NOT run the machine before removing all packaging. Mount the evaluating handle(13) on the shaft on the left hand size of the saw and fix it by tightening the set screw in the handle (fig 1). 3) Turn the elevating handle (13) (Fig 1) in the counterclockwise direction to raise the blade shaft to its highest position (Fig 3). Remove the blade fixing nut by turning in a counterclockwise direction, then pull the outer flange form the shaft and the outer arbor. Mount the blade (15) (be sure that the teeth are facing downwards at the front side of the saw. Check again that the blade is (15) securely tightened and re-fit or adjust riving knife as necessary, before remounting the table insert (17). Insert the riving knife(20), so that the long slots in the riving knife fit around the hexagon socket head end screws(Fig 4). Adjust the riving knjfe(20) so that the clearance between riving knife(20) and blade (15) is between 2 to 5 mm (Fig. Check to ensure the riving knife (20) and saw blade (15) is in line, Then check again that the blade is securely tightened and remount the table insert. Loosen the rip fence lock knobs(24) on the sliding block(19), then slide the fence(6) onto the bolt heads and tighten the rip fence lock knobs(24) (Fig. 6) To lock the rip fence(6), slide the rip fence assembly until the indicator is pointing to the desired setting. Then press rip fence lock handle (4) downwards, to lock the fence into position. Take care that the selection of the saw blade depends on the material to be cut. The Blade(15) has been adjusted at the factory, use a square to check that the blade is o at a 90 angle to the table (Fig. 7) If adjustment is needed turn the tilting lock nut (while holding the adjustment in position) to fix the adjustment. Then loosen the indicator fixing screw, set the indicator of the scale (12) on the "0o" marked then tighten the fixing screw (Fig. Turn the adjustment nut so that the blade is on the 45o position and then tighten the lock nut. When the machine is connected with the power supply, the live indicator (26) will glow. If not, please check if the power plug is well connected Should the supply be interrupted the switch will automatically default to the "OFF" position preventing a dangerous unexpected startup of the machine when the supply is restored. WARNING: Before turning the machine ON, make sure he blade guard is correctly installed and operating properly. In the event that your saw turns off during operation, turn the saw off and allow the motor to cool down for approximately 3 minutes. [. . . ] Om stå inte är att vara choiced för att montera till ditt bordlägger sågar, där är 4 spela golfboll i hål också på bordlägga sågar för montering till workbenchen. Se till alltid att ditt att bordlägga såga monteras säkert till en workbench eller en godkänd workstand. (FIG24) Pushglidning bordlägger (3) till ett bestämt placerar, och montering två skruvar en framtill sida, och annan i baken till spela golfboll i hål på avsluta av båda stänger. Use the extension table for supporting long workpieces during cutting operation. [. . . ]