User manual RYOBI ERH-650V

[. . . ] Your tool must be disconnected when not in use, before servicing, and when changing accessories such as blades, bits and cutters. Get into the habit of checking to see that adjusting keys and wrenches are removed from the tool before turning it on. Do not carry the plugged-in tool with a finger on the variable switch. [. . . ] Always press the hammer drill against the work surface (wall, ceiling, etc. When you are finished, unplug the hammer drill from the power supply and remove the chisel or drill bit. Always disconnect the hammer drill from the power supply before you change the chisel or drill bit. Wear safety goggles to protect your eyes from flying particles and splinters. When using the tool, always hold it with both hands and ensure that you have stable footing. Chisels may not be used with the ERH-650V, as this model does not have Rotostop feature. ERH-650V Voltage Power consumption No Load speed Maximum drilling capacity: - steel - concrete / stone Tool attachment Weight 230V 50 Hz AC only 650W 0 - 1100 min-1 13 mm 20 mm SDS-plus 3. To limit the maximum speed of the drill, rotate the dial on the front of the trigger until the desired setting is achieved. Lock-on button If you want to keep your hammer drill operating at a constant speed, press the lock-on button (3) while pressing the variable switch. To unlock this function, briefly press the variable switch (2) then release it. Case Hammer drill Depth stop Auxiliary handle For reasons of safety, only use the hammer drill when it is fitted with the auxiliary handle. To loosen the auxiliary handle, rotate the handle anticlockwise until the handle assy is free to move. Position the handle as required then lock securely by rotating the handle clockwise until it is tight. The depth of the hole drilled will be equal to the distance between the end of the drill bit and the front end of the depth stop. [. . . ] Het is niet mogelijk om beitelhamers met het model ERH-650V te gebruiken omdat dit model geen draaistop heeft. Curai accesoriul pe care îl vei folosi i ungei-l cu un strat subire de vaselin înainte de a-l introduce în mandrina SDS+. All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]