User manual RYOBI EMS2025SCL

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. [. . . ] Have your power tool serviced by a qualified repair person using only identical replacement parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Running at low speeds under constant usage may cause your saw to become overheated. If this occurs, cool your saw by running it without a load and at full speed. The following guidelines may be used in determining correct speed for various applications: LOW speed is ideal when minimum speed and power is required, for example starting cuts. mEDIUM speed is suitable for cutting hard metals , plastics and laminates. HIGH speed produces best results when maximum power is required, for example cutting wood. 1) Your saw is equipped with a lock-on (3) feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately. The use of a protractor is recommended when accurate cuts are required. 5) Rest the front of the saw base on the workpiece and align cutting edge of the blade with the line on your workpiece. Make sure the power cord is out of the way of saw blade and not in the line of cut. Apply downward pressure to keep the saw steady and only enough forward pressure to keep the blade cutting. DO NOT FORCE YOUR SAW Forcing your saw may overheat the motor and break saw blades. This feature is adjustable and provides faster and more efficient cutting. With orbital motion the blade cuts through your work in the upstroke but does not drag across your work in the downstroke. Slide base forward slightly to release the base from the tab on the motor housing. align the mark on the base of the desired angle with the edge of the motor housing. Once the desired angle is reached, slide the base back until the tab on the motor housing aligns with the appropriate notch on the rear of the base. 8) WARNING To avoid loss of control, broken blades, or damage to the material being cut, always use extreme caution when making plunge cuts. [. . . ] WARNING Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. LIVE TOOL INDICATOR This tool features a live tool indicator (17) which illuminates as soon as the tool is connected to the supply. This warns the user that the tool is connected and will operate when the switch is presse. 7) Lutningsvinkeln kan ställas in mellan 0° och 45°, till vänster eller till höger. [. . . ]