User manual RYOBI EBC 1040

[. . . ] ⷠChildren and adolescents must not manipulate unit, except for adolescents in training and under the supervision of a specialist. ⷠKeep all bystanders at least 5 m away from the unit during operation. [. . . ] ⷠMaintenance/servicing and cleaning of the unit or adjustments to cutting height or work height may only be performed when the motor is off/still and the main plug is disconnected. ⷠCord Sets - Make sure your cord set is in good condition. When using a cord set, be sure to use a cord that is heavy enough to carry the current that your unit wilI draw. An undersized cord set will cause a drop in line voltage resulting in power and overheating. ⷠThe table (below) shows the correct size to use depending on the cord length and nameplate amperage rating. If the electric Keep cord is bystanders at Wear head, damaged Do not Ignition/ Ignition/ least 15 m remove plug operate unit Power Switch Power Switch eye and ear away from protection. Place the safety guard onto the coupling joint pointing towards the motor as indicated in fig. CONNECTING THE CORD To prevent disconnection when you connect the extension cord to the power cord, use the cord hook (Fig. ADJUSTING LINE LENGTH The trimmer has a bump (cutting) head, which releases more trimming line without stopping the motor. When the cord starts to get a bit short, knock the cutting head on the bare ground or on hard ground to make the appliance work at top speed. EDGING When edging, let the tip of the trimming line do the work (fig. The cutting head will be at the correct angle by holding it parallel to the ground. [. . . ] All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing, We reserve the right to make changes at any time without notice. CE DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: · [. . . ]