User manual RYOBI CSD-480

[. . . ] Ensure that battery terminal will not be shorted by other metal parts such as screws nail etc. It is safer than using your hand and it frees both hands to operate the tools. It will do the job better and safer at the rate for which it was intended. [. . . ] SERVICE: Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. Ensure the outside surface of battery pack or tool is clean and dry before plugging into charger. Ensure that batteries are charged using the correct charger recommended by the manufacturer, incorrect use may result in risk of electric shock, overheating or leakage of corrosive liquid from the battery. This electric tool is manufactured in accordance with the relevant safety requirement. Repairs should only be carried by qualified persons using original spare parts otherwise this may result in considerable danger to the user. if under abusive conditions , liquid is ejected from the battery , avoid contact. Inspect the screwdriver carefully to make sure no breakage or damage has occurred during shipping. Do not discard the packing material until you have carefully inspected and satisfactorily operated the tools. Screwdriver Bits Charger Operator's Manual WARNING If any parts are missing, do not operate this tool until the missing parts are replaced. To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Following this rule will reduce the risk of electric shock, fire, or serious personal injury. Following this rule will reduce the risk of electric shock, fire, or serious personal injury. CLUTCH CAP COVER The torque is greater when the torque adjustment ring is set on higher setting and less when set on a lower. INPUT JACK This tool has been shipped in low charge condition to prevent possible problems. [. . . ] Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. This tool is in accordance with the relevant safety requirements, repairs should only be carried out by qualified person, otherwise this may result in considerable danger to the user. All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]