User manual RYOBI CMI-1802

[. . . ] 3) PERSONAL SAFETY a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injuries to person. To reduce risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage and stress. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: Model Voltage Chuck (mm) Switch No load speed (drill mode): - Lo speed (min-1) - Hi speed (min-1) No load speed (impact mode): - Lo speed (min-1) - Hi speed (min-1) Max. Battery pack (KG) Battery pack: Charger CMD-1202 12 V 13 Variable speed CMD-1442 14. 4 V 13 Variable speed CMD-1802 18 V 13 Variable speed CMI-1202 12 V 13 Variable speed CMI-1442 14. 4 V 13 Variable speed CMI-1802 18 V 13 Variable speed That pins on plug of extension cord are the same number, size and shape as those of plug on charger. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Refer to them frequently and use them to instruct others who may use this unit. CHARGING YOUR BATTERY PACK The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Note: Batteries will not reach full charge the first time they are charged. Keyless chuck Switch trigger Direction of rotation selector (Forward/Reverse) Screwdriver bits Battery pack Battery indicator Latches Depress latches to release battery pack Auxiliary Handle(For CMI-1202/1442/1802) To Tighten To Loosen Drill bit Depth Gauge Rod(For CMI-1202/1442/1802) Drilling Depth To Decrease torque To Increase torque Torque adjusting Ring Drill mode Impact mode (For CMI-1202/1442/1802) Reverse Forward 9 Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 230 volts, 50 Hz, AC only. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. [. . . ] WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. [. . . ]