User manual RYOBI CCD-1201

[. . . ] 3) PERSONAL SAFETY a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injuries to person. To reduce risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage and stress. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: Model Voltage Chuck Switch No load speed Max. Battery pack Battery pack Charger CCD-1201 12 V 10 mm Variable speed 0 - 600 min-1 10 Nm 1. That pins on plug of extension cord are the same number, size and shape as those of plug on charger. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Refer to them frequently and use them to instruct others who may use this unit. The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Note: Batteries will not reach full charge the first time they are charged. Make sure power supply is normal house voltage, 230 volts, 50 Hz, AC only. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. The LED indicator, which is located on the charging stand, will light up when charger is properly connected to power supply. This light indicates your tool is charging and will remain on until charger is disconnected from power supply. After normal usage, 3-5 hours of charge time are required to be fully charged. [. . . ] the drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, 9 WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. [. . . ]