User manual DE DIETRICH DTG1008X
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DE DIETRICH DTG1008X. We hope that this DE DIETRICH DTG1008X user guide will be useful to you.
You may also download the following manuals related to this product:
DE DIETRICH DTG1008X (10374 ko)
DE DIETRICH DTG1008X (927 ko)
DE DIETRICH DTG1008X (1516 ko)
DE DIETRICH DTG1008X (1632 ko)
DE DIETRICH DTG1008X (1516 ko)
DE DIETRICH DTG1008X (1632 ko)
Manual abstract: user guide DE DIETRICH DTG1008X
Detailed instructions for use are in the User's Guide.
[. . . ] IN YOUR OWN INTEREST, AND THAT OF SAFETY, IT IS THE LAW THAT ALL GAS AND ELCTRICAL APPLIANCES BE INSTALLED AND SERVICE BY COMPETENT PERSONS, WHO WILL COMPLY WITH THE RELEVANT STANDARDS AND REGULATIONS. CORGI REGISTERED INSTALLERS UNDERTAKE TO WORK TO SATISFCTIORY STANDARDS. DISCONNECTION OF GAS AND ELECTRIC APPLIANCES SHOULD ALWAYS BE CARRIED OUT BY COMPETENT PERSON. THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. [. . . ] USE OF THE COOKING HOB
7. 1 Hobs with knobs
7. 1. 1 Single plates Each knob shows the plate it is for. Adjustment is continuous so that the appliance also operates at any intermediate value.
7. 1. 2 Dual plates Each knob shows the plate it is for. To heat the inner cooking zone, turn the knob to the desired position (1 to 6). and then To heat both the inner and outer cooking zones, turn the knob to release. To adjust heating intensity, rotate the knob anticlockwise to the desired position. To return to heating of the inner cooking zone only, set the knob back to 0 and then turn to the desired position (1 to 6). 7. 1. 3 Description of symbols REAR LEFT REAR RIGHT
FRONT LEFT
FRONT RIGHT
7. 1. 4 Residual heat The 4 signal lamps located between the cooking zones come on when the temperature of one or more of the heating zones exceeds 60°C. The lamps go off upon temperature dropping to below approximately 60°C. 7. 1. 5 Switching off To turn off, return the knob to 0.
24
Instructions for the user
7. 2 Hobs with push-buttons
On first connection to the electrical mains, an operating check will be carried out automatically and all the indicator lights will come on for a few seconds. 7. 2. 1 Single plates When not in use, all hob components will be switched off. If the symbol of any push-button is pressed for a few seconds, the hob will switch on and the circular sectors on the buttons indicating the plate controlled by each button will illuminate. seconds after the last key is pressed, the minutes display will stop flashing and the figure 0 on the power display will start to flash. The power level must be set within another 5 seconds as described in points 7. 2. 1 / 7. 2. 2; otherwise the hob will switch off automatically. If the power is not adjusted within 5 seconds, the timer will still start the count. At the end of the time set, 3 BEEPS will sound in sequence; they are repeated 5 times at 5 second intervals. To stop the beeps in manual mode, simply press the or symbol of any push-button. 7. 2. 6 Modifying the data set During timed cooking, each single pressure on the or symbols increases or reduces the power of the plate. 5 seconds after the last button is pressed, a BEEP will sound and the display showing the time left will start flashing. The or symbols can now be pressed to increase or decrease the cooking time. A few seconds after the last cooking time adjustment, the minutes display will also stop flashing and the count will restart with the new settings. 7. 2. 7 Residual heat Each plate is equipped with a residual heat warning device. After any plate is switched off, a flashing " This warns that the cooking zone concerned is still very hot. [. . . ] INSTALLATION
10. 1 Technical information
Hob type Electrical connections HOB RATING Maximum electrical power DIMENSION OF THE HOB Width (mm) Depth (mm) See rating plate 220-240V~ 50/60Hz / 380-415V 2N 50/60Hz / 380-415V 3N 50/60Hz Electric See rating plate 720 510 588 510
10. 2 The rating plate
Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason.
MODEL
Serial N°
10. 3 Electrical connection
IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES. WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS. IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB, FOLLOWING THE INSTRUCTIONS. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DE DIETRICH DTG1008X
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DE DIETRICH DTG1008X will begin.