User manual DE DIETRICH DHG356XP1

[. . . ] The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ­ the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; ­ the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following: ATTENTION: This appliance must be earthed. When making the electrical connections, check that the current socket has a ground connection. [. . . ] This apparatus conforms to the 16. 08. 89 regulation relating to the limitation of radio-electric disturbances (EC Directive n. /6. 889 modified by the EC Directive 8/. 308. ). Fig. 2 INSTALLATION It is advisable to entrust the installation operations to specialised personnel. Installation in filtering version To facilitate installation, before starting remove the grease filter/s: press inward on the clamp at the handle and pull the filter downward (Fig. 3b Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig. To the air venting flange of the apparatus connect a proper pipe that can convey the air to the upper part of the pensile cupboard. Make the electrical connection of the hood by means of the power supply cable. Fig. 4 MODELS DHG386XP DHG316XP DHG356XP DHG376XP A 497mm DHG377XP 677. 5mm Fig. 5 Installation in ducting version Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig. 4). To get optimal conditions the air venting pipe should: be as short as possible, have the lowest number of bends (max bende angle: 90°), be made of material approved by local authorities (according to the State), have its inner side as regular and smooth as possible. It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm). Using a proper pipe, connect the air venting flange of the apparatus to the air venting hole you made beforehand. Make the electrical connection of the hood by means of the power supply cable. FUNCTIONING OF THE APPARATUS Depending on the model, the unit is equipped with the following controls: DHG356XP, DHG376XP, DHG377XP, DHG386XP CONTROLS - Fig. 6: A - Light ON/OFF switch B - Motor ON/OFF - I speed switch C - II speed switch - Pressing once more the timer starts working: it will turn the motor OFF after a 10' working time: the led blinks for all this time D - III speed switch - The timer works as for switch C E - IV speed switch - The timer works as for switch C. At the end of a working time of about 30 hours, all the leds blink all together to tell that the grease filters must be cleaned. [. . . ] The washing can be carried out in the dishwasher making sure not to let the filters make contact with dirty or silver dishes. 9b -Maintenance of the carbon filters: If you are using the filtering version apparatus, the carbon filters (Ref. : DHK306AP1) need to be changed every six months on average depending on the use made of the hood. 9a, 9b) need to be removed first in order to remove the carbon filters. [. . . ]