User manual CANDY CSTG380D

[. . . ] We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). [. . . ] This option allows deep cleaning of your clothes by maintaining the same temperature for the whole wash. TEMPERATURE SELECTION button l This button allows you to change the temperature of the wash cycles. L It is not possible to raise the temperature over the maximum allowed for the programme, in order to protect the fabrics. L If you want carry out a cold wash all the indicators must be off. 57 EN SPIN SPEED button l By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. L The key lock can be simply cancelled by pressing the two buttons simultaneously again or turning off the appliance. Digital Display The display’s indicator system allows you to be constantly informed about the status of the machine. L If the label does not indicate specific information, it is possible to use the maximum spin expected in the program. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. 1 2 34 6 7 l To reactivate the spin cycle press the button until you reach the spin speed you would like to set. L It is possible to modify the spin speed without pausing the machine. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the program and increase water consumption. 5 1) OPTIONS INDICATOR LIGHTS The indicator lights show the options that can be selected by the relevant button. 2) CYCLE DURATION l When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected. The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the noise and vibration in the machine and so prolongs the life of your machine. L During the initial filling phase of the cycle the machine calculates the actual cycle time needed based on the load size, content and options selected. This time can recaulculate during the wash depending on detergent levels and load balancing. 3) DOOR LOCKED INDICATOR LIGHT KEY LOCK l Pressing simultaneously the buttons TEMPERATURE SELECTION and SPIN SPEED for about 3 seconds, the machine allows you to lock the keys. In this way, you can avoid making accidental or unwanted changes if a button on the display is pressed accidently during a cycle. L The indicator light is illuminated when the door is fully closed. 58 l When START/PAUSE is pressed on the machine with the door closed, the indicator will flash momentarily and then illuminate. [. . . ] This may be due to a leak from the seal between the tap, supply hose and fill valve; in this case, replace it and tighten the hose connections correctly. The machine is fitted with a detection system that protects the load and product from damage if the load is not balanced before spinning. This may result in:• The machine attempts to balance the load, increasing the time of spin. If this is experienced remove the load de-tangle it, reload it and restart the spin program. [. . . ]