User manual CANDY CDIM 6766

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CANDY CDIM 6766. We hope that this CANDY CDIM 6766 user guide will be useful to you.


CANDY CDIM 6766 : Download the complete user guide (1971 Ko)

Manual abstract: user guide CANDY CDIM 6766

Detailed instructions for use are in the User's Guide.

[. . . ] The guarantee applies to Gt Britain and Northern Ireland only, and is an addition to your statutory rights. For service and repairs call your local engineer on our national telephone number: Description of the control panel Technical data Programme selection and special functions Programme guide The Waterblock system Water softener unit EN 50242 place load Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage Power consumption of the off-mode and of the left-on mode: 0, 30 W / 0, 45 W *Values are measured in a laboratory according to European Standard EN 50242 (consumption may vary according to conditions of usage). These buttons allow to modify the wash intensity, according to how dirty the dishes are. Pressing the button + the intensity of Wash will be increased, pressing the Button ­ the intensity of wash will be Reduced and the wash time will be remarkably shorter. [. . . ] Once selected, this option keeps being on (light on) also for next washing cycles and it can be de-activate (light off) only by pressing the button once again. Before starting a new programme, you should check that there is still detergent in the dispenser. IMPORTANT This option is recommended when using the RAPID 24' program, the duration of which will be extended for about 15 minutes, allowing the detergent tablets to achieve a better performance. Dishwasher start time can be set with this button, delaying start from 1 to 23 hours. proceed as follows to set a delayed start: Press the "DELAY START" button ("00" will appear on the display). Press the button again to increase the delay in hours (each time the button is pressed the delay is increased by 1 hour to a maximum of 23). To start the countdown press the "START" button (the "DELAY START" indicator light will start to flash). At the end of the countdown, the programme will automatically start (the "DELAY START" indicator light will turn off). If you wish to see which programme has been selected, press the "PROGRAMME SELECTION" button. proceed as follows to cancel a delayed start: Hold the "RESET" button down for at least 5 seconds. "00" will appear on the display and some audible signals will sound. At this point, a new programme and option buttons must be set to start a new programme as indicated in the "PROGRAMME SETTINGS" section. The alarm for the programme end may be muted as follows: IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 15 seconds (during this time, 2 audible signals will sound). Release the button when the second audible signal sounds ("b1" will appear on the display to indicate that the alarm is on). Press the same button again ("b0" will appear on the display to indicate that the alarm is off). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. Memorization of the last programme used The last programme used can be memorized by following the below: IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Press the same button again ("A1" will appear on the display to indicate that the memorization is on). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). [. . . ] If the hose is not long enough for correct connection, it must be replaced with a longer one. This dishwasher is also equipped with an anti-overflow safety device which, if water exceeds normal levels due to malfunctions, automatically blocks water flow and/or drains excess quantities. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CANDY CDIM 6766




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CANDY CDIM 6766 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.