User manual CANDY CDIM 6120 PR
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CANDY CDIM 6120 PR. We hope that this CANDY CDIM 6120 PR user guide will be useful to you.
Manual abstract: user guide CANDY CDIM 6120 PR
Detailed instructions for use are in the User's Guide.
[. . . ] The guarantee applies to Gt Britain and Northern Ireland only, and is an addition to your statutory rights. For service and repairs call your local engineer on our national telephone number: EN 50242 place load Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage Power consumption of the off-mode and of the left-on mode: 0, 30 W / 0, 45 W *Values are measured in a laboratory according to European Standard EN 50242 (consumption may vary according to conditions of usage). These buttons allow to modify the wash intensity, according to how dirty the dishes are. Pressing the button + the intensity of Wash will be increased, pressing the Button the intensity of wash will be Reduced and the wash time will be remarkably shorter. [. . . ] IMPORTANT This option is recommended when using the RAPID 24' program, the duration of which will be extended for about 15 minutes, allowing the detergent tablets to achieve a better performance. Dishwasher start time can be set with this button, delaying start from 1 to 23 hours. proceed as follows to set a delayed start: Press the "DELAY START" button ("00" will appear on the display). Press the button again to increase the delay in hours (each time the button is pressed the delay is increased by 1 hour to a maximum of 23). To start the countdown press the "START" button (the "DELAY START" indicator light will start to flash). At the end of the countdown, the programme will automatically start (the "DELAY START" indicator light will turn off). If you wish to see which programme has been selected, press the "PROGRAMME SELECTION" button. proceed as follows to cancel a delayed start: Hold the "RESET" button down for at least 5 seconds. "00" will appear on the display and some audible signals will sound. At this point, a new programme and option buttons must be set to start a new programme as indicated in the "PROGRAMME SETTINGS" section. The alarm for the programme end may be muted as follows: IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 15 seconds (during this time, 2 audible signals will sound). Release the button when the second audible signal sounds ("b1" will appear on the display to indicate that the alarm is on). Press the same button again ("b0" will appear on the display to indicate that the alarm is off). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. Memorization of the last programme used The last programme used can be memorized by following the below: Press the same button again ("A1" will appear on the display to indicate that the memorization is on). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 30 seconds (during this time, 3 audible signals will sound). Release the button when the THIRD audible signal sounds ("A0 " will appear on the display to indicate that the memorization is off). [. . . ] If any problem occurs, turn the dishwasher off by pressing the "ON/OFF" button and start the procedure again from the beginning (STEP 1). This model is provided with an indicator light on the control panel which will light up when it is necessary to reload the salt container. IMPORTANT The appearance of white stains on dishes is generally an important sign that the salt container needs filling. Wash with prewash For wash programmes with prewash, it is advisable to add a second dose of detergent (max. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CANDY CDIM 6120 PR
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CANDY CDIM 6120 PR will begin.