User manual CANDY CBP612

[. . . ] Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10 -5 bar). Before connecting the model to the electricity network: - control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. [. . . ] If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Installation Attention: should the lamps not work, make sure they are well tightened. Mounting of the hood between two hanging cupboards Drill 2 holes of 2, 5 mm diameter on the side of the hanging cupboards as showed in the fig. 1 considering also the thickness of the front panel, so that the hood remains at the same level of the side hanging cupboards. Fix the hood to the hanging cupboards through 4 screws, which are appropriate to that kind of cupboard. Close the room, which eventually remains between the hood and the wall adjusting the spacer (L) by acting on the appropriate screws (P) fig. Mounting of the hood on the wall Drill 6 holes on the wall as showed in fig. Fix the spacer (L) on the wall at the right height, according to the depth of the hanging cupboards fig. Fix the hood on the wall through 4 screws and dowels with expanding plug , which are appropriate to that kind of wall (ex. Fixing of the front panel Take off the door (E) by removing the grill (G) and pulling at the same time the special spring locking knobs (H) fig. Fix the door on the front panel through the screws at the level indicated in fig. Replace the door by inserting it in the upper and lower slides until the spring locking knobs (H) are released. Extraction through an outside wall The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange B (Fig 5). [. . . ] The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). The acrylic filter, which is found resting on the grille, should be replaced when the text, visible through the grille, changes colour and the ink spreads; the new filter should be fitted in such a way that the text can be seen through the grille from outside the cooker hood. If the filters do not have any text on them, or if metal filters or aluminium panel filters are used, they should be washed every 2 months in order to prevent the risk of fire. [. . . ]