User manual BLACK & DECKER DN 83

[. . . ] Do not force small tools or attachments to do the job of a heavy duty tool. Do not use the tool for purposes not intended; for example, do not use a circular saw to cut tree limbs or logs. Do not wear loose clothing or jewellery as they can be caught in moving parts. Rubber gloves and non-skid footwear are recommended when working outdoors. [. . . ] MAINS PLUG REPLACEMENT (UK ONLY) Should the mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact a Black & Decker service agent or a qualified electrician. A plug with bared copper conductors is very dangerous if engaged in a live socket outlet. €¢ Only fit BS1363A approved plugs fitted with the correctly rated fuse. €¢ The cable wire colours, or a letter, will be marked at the connection point of most good quality plugs. Attach the wires to their respective points in the plug (see diagram). fit amp fuse Fit a plug Fit aa55amp fuse E (KA83) approved or 13 amp L to BS1363A fuse (KA75) N Warning!MAINS PLUG REPLACEMENT (AUSTRALIA AND NEW ZEALAND ONLY) Should the mains plug or cordset of the product be damaged, it must only be replaced by an authorised Black & Decker service agent because special purpose tools are required. EXTENSION CABLES Up to 30m (100ft) of 3-core extension cable can be used without undue loss of power. Note: An extension cable should not be used unless absolutely necessary. Use of an improper extension cable could result in a risk of fire and electric shock. If an extension cable must be used, make sure it is properly wired, contains the correct rated fuse as recommended in its literature and is in good electrical condition. UNWANTED TOOLS AND THE ENVIRONMENT Should you find one day that the tool needs replacement or is of no further use, think of the protection of the environment. Black & Decker service agents will accept old tools and will dispose of them in an environmentally safe way. THE BLACK & DECKER GUARANTEE (UK, AUSTRALIA AND NEW ZEALAND ONLY) If the Black & Decker product becomes defective due to faulty materials and workmanship, within 24 months from the date of purchase, we guarantee to either replace all defective parts or at our discretion, replace the unit free of charge provided that: • The product is returned to us or our authorised repairers with evidence of date of purchase. €¢ The product has not been used for trade, professional or hire purposes. • The product has not been subjected to misuse or neglect. €¢ The product has not sustained any damage through foreign objects, substances or accidents. €¢ Repairs have not been attempted by anyone other than our authorised repair agents. This guarantee is offered as an extra benefit and is additional to the customers statutory rights. aFTER SALES SERVICE FOR THE BLACK & DECKER PRODUCT (UK , AUSTRALIA AND NEW ZEALAND ONLY) Black & Decker offers a nationwide network of authorised service agents. The use of other than genuine Black & Decker accessories and parts may 5 Connect blue to N (neutral) Make sure that the outer sheath of the cable is held firmly by the clamp Connect brown to L (live) 240 volts AC only. [. . . ] ADJUSTING THE SANDING BELT TRACKING After you change the sanding belt, proceed as follows: Connect the plug to the electricity supply and switch on your belt sander. Check that the sanding belt runs parallel with the outer edge of the motor housing. To adjust the tracking, turn the tracking adjustment knob (4) clockwise or anticlockwise as necessary, until the sanding belt runs parallel with the outer edge. 5m/s2 Brian Cooke - Director of Engineering Black & Decker Ltd, Spennymoor, County Durham DL16 6JG United Kingdom The Black & Decker policy is one of continuous improvement to our product and as such we reserve the right to change the product specification without prior notice. [. . . ]