User manual BEKO HSA24520

[. . . ] Make your old appliance useless : - disconnect the appliance from the supply; - remove the supply cord (cut it); - remove the eventual locks on the door to avoid the blocking of children inside, while playing, and the endangering of their lives. The refrigerating apliances contain insulating materials and refrigerants which require a proper recycling. This appliance is not intended for use by person with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] ⷠThe appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it. This appliance was designed to operate at an ambient temperature between +100C and +430C (SN/T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. 100 cm from the cookers working with coal or oil; · Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. Place the appliance in a perfectly even, dry and well ventilated place. The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. Green LED ­ shows that the appliance is supplied with electric energy. Red LED ­ damage ­ lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred. Orange button­ fast freeze ­ by pushing it the orange led goes on, showing that the appliance entered into the "fast freeze" mode . The exit of this mode is done by pushing the button again, and the orange led goes off. The three LEDs give information about the mode of operation of the freezer. Before putting into operation, clean the inside of the appliance (see chapter , , Cleaning"). After finishing this operation please plug in the appliance, adjust the thermostat knob to an average position. Leave the appliance work for about 2 hours without putting food inside it. [. . . ] After the melting of the ice and the run-off of the water please wipe with a cloth or with a sponge, then dry well. Do not use hairdryers or other electric heating appliances for defrosting. ⷠIt is advisable to clean the appliance when you defrost it. ⷠWash the inside with lukewarm water where you add some neutral detergent. [. . . ]