User manual BEKO DWD8657

[. . . ] contents Introduction Welcome Know your dishwasher / specification Standards and testing information / EC declaration of conformity Warning and safety information Electrical Safety Childrens safety General Recycling Energy and water saving What should not be washed in your dishwasher Before first use Turbo Fan Heat Drying System Installation Electrical requirements This appliance must be earthed Fitting a different plug Water inlet hose connection Drain hose connection Installation of dishwasher How to use Water hardness & Regeneration settings Filling the (Water softener) Dishwasher salt Detergent use Filling the detergent dispenser Rinse aid Filling the rinse aid dispenser Loading the Dishwasher Folding plate support rods Three-way split cutlery basket Upper basket height adjustment (Unloaded) Standard loading and testing institute information Operating the dishwasher Function buttons On/Off button Start / Pause / Cancel button Programme Selection button Time Delay (+) / (-) button Extra drying buttons 2 4 4 5 5 5 5 6 6 6 6 6 7 7 7 7 8 8 9 10 10 11 12 13 13 13 14 14 15 15 16 17 18 18 18 18 18 18 Half / Load button Using your Dishwasher Programme selection Adding function to the program Time delay Child lock Salt indicator Rinse aid indicator Rinse aid indicator setting Cancelling a programme Changing the programme Programme progress display Salt and rinse aid indicators Unloading the dishwasher Programme table How to clean your Dishwasher Stainless steel door cleaning instructions Filters Upper spray arm Lower spray arm 18 19 19 19 19 20 20 20 20 20 20 21 21 21 22 23 23 24 24 24 Before calling service / Trouble shooting 25 Guarantee 27 How to obtain service 27 3 Top Spray Removable work top Turbo Fan Heat Drying System Upper basket Upper basket track latch Upper spray arm Heating element concealed behind the liner Lower spray arm Filters Dishwasher salt cap Lower basket Cutlery basket Detergent and Rinse aid dispenser Programme Selection&Starting Guide Removable kick plate Programme selection button Half load button 3 (-) Button LCD Display (+) Button Start / Pause / Cancel indicator light On/Off button Extra drying button Handle Start / Pause / Cancel / button specification Load Capacity Height Width Depth Depth/Height (without worktop) Net weight Supply voltage Fuse currrent Total power Heater power Pump powers : 12 Place settings : 850 mm : 598 mm : 598 mm : 570 mm / 820 mm : 49 kg : 220-240 V ~ 50 Hz : 13 A : 1900-2200 W : 2000 W : 90/30 W Diameter of plates for : Upper basket : 25 cm max. Lower basket : 31 cm max. Because we continually strive to improve our products, we may change our specifications and designs without prior notice. This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC directives. 4 73/23/EC 89/336/EC 93/68/EC IEC 436/DIN 44990 EN 50242 The dishwasher should only be operated on the voltage specified. The life of your machine and your safety depend on you using an electrical installation compliant to standards. [. . . ] (C) may be set between levels 1 and 6 (6 being the maximum amount of rinse aid usage). According to the finish and drying results obtained, adjust the dose of rinse aid by means of the six position selector. (Position 1: minimum dose, Position 6: maximum dose. ) Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. If the dishwasher is considerably full and the dishes are relatively dirty, fill the main container (A) up to 25cm³ level. If the dishwasher is not quite full and the dishes are only slightly soiled, fill the main container (A) only up to 15cm³ level. If your dishes are kept unwashed for a long time and the food particles are stuck on the dishes also fill the small container (B) up to 5cm³. Depending on the degree of soiling and the water hardness in your area it may be necessary to add more detergent. If you are using tablet detergent read the manufacturers recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (detergent dispenser, cutlery basket, etc. ) After you put in the detergent, shut the container lid (D) and ensure you hear the clicking sound. During the wash programme the detergent will dispense automatically and the lid (D) will remain open when the programme finishes. Do not use detergent when using the pre-wash programme. Open the rinse aid dispenser lid by pressing the button as shown in the diagram. Fill up with rinse aid until the container is full to level of max mark . Make sure you clean any rinse aid that you might have spilled. Dark = sufficient rinse aid Light = add rinse aid 13 Loading the dishwasher correctly will increase the washing, drying and energy performance of your machine. Examine the information given in this section and the information stated in the Programme chart and quick reference card given with the manual. Remove any large scraps of food from the dishes before placing in the dishwasher to avoid clogging the filters. Place large or heavily soiled items in the lower basket, and small, light or delicate articles in the upper basket. Put forks, small and medium size knives and spoons in the cutlery basket. Long-stemmed glasses should lean against the basket, the racks, or the supports not against the dishes. The shelves on the rack are made height adjustable to accommodate tall items. When loading your dishwasher please ensure tall glasses (and/or wine glasses) rest against the sides of the upper basket. Do not allow tall glasses to rest against each other since they may be damaged during washing if not properly supported. You can fold the racks in the upper basket when you need more space for larger items. An optional Glass Holder part is available that could be fitted to the upper basket as shown in the diagram. [. . . ] Incorrect repositioning of the filters will produce poor washing results. Cleaning of the filters is vital to ensure correct operation of the machine. Lower spray arm Turn the nut anti clockwise and remove both the nut and the spray arm. Put the spray arm back on and screw on the nut turning clockwise until a clicking sound is heard. [. . . ]