User manual BEKO 28422ND/S

[. . . ] ⷠFollow the instructions, especially those for safety. ⷠKeep the manual in an easily accessible place as you may need it later. ⷠBesides, read also the other documents provided with your product. Symbols and their descriptions This instruction manual contains the following symbols: C Important information or useful usage tips. [. . . ] If your product is equipped with a cooling system that contains R134a. You can see the gas used in production of your product on the rating plate that is located on the left inner part of it. Things to be done for energy saving Do not leave the doors of your refrigerator open for a long time. Do not overload your refrigerator so that the air circulation inside of it is not prevented. Do not install your refrigerator under direct sunlight or near heat emitting appliances such as ovens, dishwashers or radiators. Please remember that the manufacturer shall not be held liable if the information given in the instruction manual is not observed. Least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. The ambient temperature of the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions than this is not recommended with regard to its efficiency. Please make sure that the interior of your refrigerator is cleaned thoroughly. If two refrigerators are to be installed side by side, there should be at least 2 cm distance between them. If your appliance is equipped with an air grille, please refer for installation of the air grille. Should the light fail to work switch off at the socket outlet and pull out the mains plug. Follow the below instructions to check if the light bulb has worked itself loose. If the light still fails to work obtain a replacement E14 screw cap type 15 Watt (Max) bulb from your local electrical store and then fit it as follows: 1. "Replacement light bulb can easily be obtained from a good local electrical or DIY store. If your refrigerator is unbalanced; You can balance your refrigerator by turning the front legs of it as illustrated in the figure. The corner where the leg exists is lowered when you turn in the direction of black arrow and raised when you turn in the opposite direction. Taking help from someone to slightly lift the refrigerator will facilitate this process. ) Cookers or other heat sources must not be placed above the counter where the appliance is installed under the counter. ⷠThe mains wall socket plug must be close to the right or left hand side of the appliance. There are 4 screws(2 pieces at the back, 2 pieces below the front edge) that should be removed. [. . . ] compressor is not running · Protective thermic of the compressor will blow out during sudden power failures or plug-out plug-ins as the refrigerant pressure in the cooling system of the refrigerator has not been balanced yet. ⷠYour refrigerator will start running approximately after 6 minutes. Please call the service if your refrigerator does not startup at the end of this period. ⷠThe refrigerator might have been plugged in recently or might have been loaded with food. [. . . ]